12/20/2023 0 Comments Gigabyte raid monitorThis won't hurt anything and you can move the SSD back depending on the results. Just curious to see the disk I/O between different controller and with the disks on the same controller. Then test the file copy operation I mentioned above and compare. ![]() Perform another round of benchmarking and see which is better. You might have to use a certain port (refer to your manual) don't recall. It should operate as standalone SATA in AHCI mode, even with the operate mode set to RAID. Now move the SSD to the Intel controller. Use the largest file you have and copy it back and forth between the SSD and array. Use that as a baseline for the Marvel controller. Take the results off all tests and divide by 4. That said, searching google shows a mixed bag of reviews for the controller.ĭo 3 or more consecutive tests with Crystal Disk Mark. Not sure why the gentlemen in the post from 2012 suggests you will have "long term problems" connecting your boot drive to the 9128 controller. I would disable any of the controllers you don't have devices connected to as this will speed up boot time. You must have the ICH10R set to RAID mode correctly if its currently hosting your 0+1 arrays. The controller operate mode should be set to AHCI. You should be able to select this as a primary boot device in the boot order. If your boot drive is SATA6, it will run the fastest on the Marvel controller. This is a standard marketing selling point used by all motherboard manufacturers. When two disks are connected, each channel is capable of 1.5Gbps or 3.0 (Marvell). So when one drive is connected to any of them except the Marvell, you will see up to 3Gbps performance (and up to 6Gbps) on the Marvel. The Marvell 9128 is the only controller that supports SATA6, but there are only 2 ports.Īll of the controllers except the intel have 1 PCIe lane. The ICH10R is the only controller that supports RAID10 In regards to the JMicon controller, it supports eSATA disks (1-2) as single SATA or RAID 0~1 You have identified the SATA controllers function on the board correctly. But since there's only two of those, I'm only going to be able to connect an SSD to it. But now that I look at it, there are also 6Gb/s Marvell SATA ports. How should I be connecting them up to the motherboard for maximum performance? Also what settings do I need in BIOS?Īt the moment, I have my SSD and 7200RPM HDDs all plugged into the sky blue ports. I have 1 SSD which I use to boot W7 from and x4 7200RPM HDD in RAID10 for data on a separate drive. ![]() X2 SATA 3Gb/s through the gigabyte SATA2 chip. X2 SATA 6GB/s through the Marvell 9128 chip. X2 eSATA 3GB/s ports through the jmicron JMB362 chip which is obviously eSATA in BIOS (the plugs for these appear to be next to the USB ports and I don't use them. The MB has 圆 sky blue SATA 3Gb/s ports which I presume are simply called SATA3 in BIOS? I'm trying to figure out how to get the most hard drive performance out of it. Re-installing my computer, so decided to delve into setting it up properly. This Mobo is old (here's a link ) but I never learned how to set it up properly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |